Operation Manual

Rear Panel

AUX INPUT

This 1/8" input jack allows you to connect a CD player or MP3 player to your MAX

Series bass amp

and play along

POWER SWITCH/DDT

™

INDICATOR LIGHT

This dual-purpose switch is used to turn the amp on and off. When the DDT (Distortion Detection

Technique) senses power amp clipping, a protection circuit is engaged and the LEDs in the power switch

change to red.

CAUTION: The on/off switch in this unit does not break both sides of the primary mains. Hazardous

energy can be present inside the chassis even when the on/off switch is in the OFF position.

AC POWER INLET:

This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to

this connector to provide power to the unit. Damage to the equipment may result if improper line volt-

age is used. (See line voltage marking on unit).

Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does

not have a ground pin, a suitable grounding adapter should be used, and the third wire should be

grounded properly. To prevent the risk of shock or re hazard, always make sure that the amplier and

all associated equipment is properly grounded.

NOTE: FOR UK ONLY

As the colors of the wires in the mains lead of this apparatus may not correspond with the colored mark-

ings identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yel-

low must be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored

green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is

marked with the letter N, or the color black. (3) The wire that is colored brown must be connected to the

terminal that is marked with the letter L, or the color red.Putet, quisci tisl et adionsenibh esequi ting et