Operation Manual

Tour
™
Series Specications
NOTE: All specifications tested
with mains voltage maintained
at nominal level.
Line Voltage:
100 VAC to 240 VAC 50/60 Hz
universal power supply
CAUTION: Do not switch line
voltage while unit is powered
on. Doing so may cause damage
to unit.
Typical Power Consumption:
100 W
Power Amplifier Specifications:
Protection:
DDT
™
speaker protection with
defeat switch
Short Circuit protection
Thermal protection circuit
Cooling fan failure protection circuit
Current limit protection circuit
DC output protection circuit
Input Sensitivity (signal into
return jack with master volume
set to 5):
7.32 dBu
Power Output:
All measurements with no more than
1% THD + N
8 ohms 200 watts (40.0 VRMS)
4 ohms 300 watts (34.6 VRMS)
Headphone Amplifier
Specifications:
Stereo 8 ohm minimum load
Power Output:
All measurements with no more than
1% THD + N
8 ohms 250 mW (1.41 VRMS) x2
Preamplifier Specifications
Settings for the following
Measurements (unless stated
otherwise):
PRE GAIN: 5 (12 o'clock)
BRIGHT: Out
CONTOUR: Out
CRUNCH: Out
LOW: 0 (12 o'clock)
HIGH: 0 (12 o'clock)
GRAPHIC EQ: All sliders set to center
GRAPHIC EQ SWITCH: Out
COMPRESSION: Out
POST GAIN: 10 (fully clockwise)
DDT
™
: Active
Input Sensitivity (Input selector
set to passive):
Nominal Input: -17.8 dBu
Minimum Input: 40.9 dBu
Maximum Input: 1.3 dBu (maximum
signal at input before clipping)
Input Sensitivity (Input selector
set to active):
Nominal Input: -3.80 dBu
Minimum Input: -31.3 dBu
Maximum Input: 10.2 dBu
(maximum signal at input before
clipping)
D.I. XLR Output:
Balanced output driven pre-EQ by
buffered instrument signal Foot Switch
jack:
Ground switching type, TRS phone
plug (T = compressor, R = CRUNCH,
S = ground)
Weight:
73.4 lbs.
Dimensions (h x w x d):
22.0" x 23.3" x 19.5"
Tour Series TNT
®
Combo
NOTE: All specifications tested with mains voltage maintained at nominal level.
Features and specifications subject to change without notice.