Operation Manual



Input connections are made via the 3-pin XLR (pin 2+) or 6.3 mm plug combination connectors on the rear panel of the

amplifier. The inputs are actively balanced. The input overload point is high enough to accept the maximum output level of

virtually any signal source.



This XLR jack supplies parallel output signals from the associated channel for patching to this amplifier and/or additional

power amplifier inputs. The Thru/Out jack is affected by the position of the associated Channel Mode switch. This XLR jack

also provides an unbalanced (tip/sleeve) output to be patched with single-conductor shielded cables.



All models have one combination 4 pole twist lock output connector per channel. Channel A ouput allows for CH A 1+ Pos / 1-

Neg and channel B 2+ Pos / 2- Neg to use a single 4 conductor speaker cable.



In the unlikely event of operating conditions that may potentially damage the amplifier, the circuit breaker may trip. After

inspecting the cables and connections, the amplifier can be reset. If the circuit breaker trips a second time, contact the local

Peavey authorized service center.



This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to

provide power to the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking on

unit).

Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a

suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire

hazard, always make sure that the amplifier and all associated equipment is properly grounded.



As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the

terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal

which is marked by the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire which is colored

blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored

brown must be connected to the terminal which is marked with the letter L, or the color red.

Rear Panel

IPR2

™



IPR2

™

