Operation Manual

29
Volume
Mode
To select an item from the Main Menu, rotate the encoder until the cursor marks the selection you want. Press the encoder to
navigate to the Sub Menu adjustment screens for that processing function. When you enter a processing function Sub Menu, the
cursor will appear in the upper left corner of the screen allowing you to scroll through Sub Menu screens. To edit a parameter, press
the encoder to move the cursor to the desired parameter on the screen. Turning the encoder then adjusts that parameter. To scroll
to another screen, press the encoder to return the cursor to the upper left corner of the screen. You can now scroll through Sub
Menu screens.
Volume
The current gain settings are always available in the main menu
screen. The dedicated encoders on the front panel are used for
adjustment of the A and B channels in stereo and mono modes.
If the input mode is set to Bridge, the Channel B control is not
active and the volume display shows “na.”
Stereo Input Mode
Stereo: Inputs A and B go to outputs A and B.
Mono Input Mode
Mono: Input A drives both outputs A and B.

To reset the DSP and discard edits, select “Discard and Exit”
from the Sub Menu to delete the edits made since entering the
Sub Menu.

The final screen in most process Sub Menus is “Save and Exit.”
Press the encoder in this screen to save the edits and return to
the main menu.

is selected and you return to the main menu. Turning off the
amplifier while editing in a Sub Menu gives the same result as
