Operation Manual

MMaaiinn LLiinnee OOuutt ((22))

These low-noise‚ electronically balanced XLR connectors can be used to route signals to a mixing

console‚ recording device‚ etc.

SSeenndd//RReettuurrnn JJaacckkss MMaaiinnss ((33 && 44))

Two stereo pairs of 1/4" jacks allows the use of various auxiliary units (effects units‚ equalizers‚ etc.)

in-line‚ before the power amp section.

HHeeaaddpphhoonnee JJaacckk ((55))

This 1/4" jack accepts stereo headphones only.

CCHH55//MMoonniittoorr IInnppuutt JJaacckk ((66))

Use this 1/4" jack to connect to the output of any line-level device.

CChhaannnneell 44

((CChhaannnneell 33 iinnppuutt oonn KKBB44))

HHiigghh--IImmppeeddaannccee IInnppuutt ((77))

This pair of 1/4" jacks accepts high-impedance microphones or line-level sources equipped with left

and right 1/4" phone plugs.

CChhaannnneell 44

((CChhaannnneell 33 iinnppuutt oonn KKBB44))

LLooww--IImmppeeddaannccee IInnppuutt ((88))

For use with low-impedance microphones or other line-level sources equipped with a male XLR

connector.

CChhaannnneell 44

((CChhaannnneell 33 iinnppuutt oonn KKBB44))

SSeenndd//RReettuurrnn JJaacckk ((99 && 1100))

This pair of 1/4" jacks allows the use of various auxiliary units (effects units‚ equalizers‚ etc.) in-line.

CChhaannnneell 33‚‚ 22 && 11

((CChhaannnneell 22 && 11 oonn KKBB44))

IInnppuuttss ((1111‚‚ 1122 && 1133))

This pair of 1/4" jacks accepts high-impedance microphones or line-level sources equipped with left

and right 1/4" phone plugs.

EExxtteerrnnaall SSppeeaakkeerr JJaacckk ((1144))

This 1/4" jack provides the powered signal from the amplifier. Use this jack to add a second speaker

cabinet in parallel. The external minimum speaker load impedance is 8 ohms.

IIEECC ccoonnnneeccttoorr//ddeettaacchhaabbllee lliinnee ccoorrdd ((1155))

This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings

for the intended operating voltage is included in the carton. The mains cord should be connected to

the amplifier before connecting to a suitable AC outlet.

UU..SS.. DDoommeessttiicc AACC MMaaiinnss CCoorrdd

The mains cord supplied with the unit is heavy-duty‚ 3-conductor type with a conventional 120 VAC

plug with ground pin. Never break off the ground pin on any equipment. It is provided for your safety.

If the outlet used does not have a ground pin‚ a suitable grounding adapter should be used and the

third wire should be properly grounded.