MODEL 8050-02 & 10850-02 PECS) PECS OWNERS MANUAL FOR A 50 CUBIC FOOT PASTURE VAL UNIT CONGRATULATIONS AND THANK YOU FOR BUYING THE PECS LAWN VACUUM. Your new PECS Vac has been engineered and manufactured to OPEC's high standards for safety, quality, dependability, and ease of operations.
WARRANTY A. WHAT IS WARRANTED? Peso extends the following warranties to the original purchaser of each new Peso consumer product subject to the following limitations, 1. PRODUCT WARRANTY. Any part of any consumer product which is defective in material or workmanship's delivered to the purchaser will be repaired or replaced, as Peso elects, without charge for parts or labor, if the defect appears within 12 months from the date of delivery of the product to the original purchaser.
Outdoor Power Equipment Institute Recommendations WARNING TO PURCHASERS OF INTERNAL COMBUSTION ENGINE EQUIPPED MACHINERY OR DEVICES IN THE STATE OF CALIFORNIA: The equipment which you have purchased does not have a spark arrested muffler. if this equipment is to be used on any forest covered and brush covered {and or grass covered unimproved land in the state of California, the law requires that a spark arrested muffler be installed and be in effective working order.
ASSEMBLY STEP 1: Slide the engine mount arm assembly into the tongue of the base frame. Line up the holes and secure with (3) x hex bolts & (3) flange nuts. STEP 2: Before mounting the engine place the rubber shock absorbents (PROVEN 1099) onto the engine mount plate and align the holes. {The rubber shock absorbents should be sandwiched between the mount plate and the base of the engine.) Place thé engine on the mount plate with the negative (Black) cable between the engine and the plate.
ASSEMBLY STEP 4: To mount the Bose hanger, slide the threaded bolt through the hole at the rear of the engine mount arm. Slide the pinch plate over the bottom of the bolt stud and secure with 2 flange nut. Place the plastic plug into the upper end of the hanger, 2 small amount of adhesive may be required. STEP 5: Place a hose clamp over each end of the 7 upper flex hose. Attach one end to the top of the blower housing, Slide the other end over the inlet ring. Tighten the hose clamps.
OPERATION JACK STAND Your Pasture-Vac is equipped with either the standard flat plate or a (optional) caster mounted jack stand. Pull the locking pin out, and remove the Jack Stand, TEA _ Folktale and re-inset pin, WAND When using the wand attachment operate the engine at full throttle. Hold the wand so that the beveled bottom edge is parallelism to the ground as it is pushed forward in a scooping motion.
ELECTRICAL AND FUEL SYSTEMS PEC) BLEEDING THE FUEL LINES diesel ony) Air car enter the fuel systemic when the engine * is first installed, or when the fuel line is removed. To remove the air, bleed the stem according to the following instructions. *Place the regulator in the normal position. *(pen the fuel cock. *(pen the decompression lever, * Loosen the cap nut (fuel injection valve side) of the high pressure fuel pipe.
MAINTENANCE Your Pecs Lawn Vac was designed and built to provide years of service with only minor care. Certain tasks however must be performed to keep tin good operating condition and to avoid costly repairs. This section describes and provides procedures forth necessary care of the Lawn Vac. [ SCHEDULED CARE | CARE REQUIRED : 1 Before Each Use Check engine oil. Check all hose connections. After Each Use Clean Collector Box, hoses and engine of all grass and dirt.
TROUBLE SHOOTING €[J51) Diagnostic Procedures Trouble shooting procedures are provided in the chart below. To use these procedures, first locate the problem below that best describes the trouble you have encountered. Check the possible causes in the list one at a time. Correct any problems that are found and operate the vacuum collector again to verify that you have eliminated the problem. DO NOT attempt any major repairs without first contacting your dealer. [PROBLEM CAUSE SOLUTION Leaves and Grass 1.
