F5 TYPHOON BLOWER TABLE OF CONTENTS SECTION PAGE SECTION PAGE {IMPORTANT INFORMATION il BLOWER ASSEMBLY INSTRUCTIONS 1-4 introduction Features 3-2 Throttler Diverted Control Installation 3-4 Handle installation vv Oceania 1-3 Description ~ 3-3 Throttle Cable Removal And Installation ~~ 13.
1-3 DESCRIPTION MODEL F58500 KOHL ER COMMAND PRO KOHL ER ENGINE BLOWER HOUSING GAS SHUT-OFF VALVE % AIR FILTER OFFEND, AIR DEFLECTOR CONTROL THROTTLE CONTROL Ho, AIR DEFLECTOR oes PIVOT LOCK PIN =.
1-3 DESCRIPTION MODEL F5800 BRIGGS AND CASTRATION AIR DEFLECTOR CONTROL THROTTLE CONTROL BRIGGS & CASTRATION ENGINE BLOWER, HOUSING AIR DEFLECTOR ENGINE OIL DIPSTICK ADD ENGINE OL GAS TANK PIVOT LOCK PIN GAS PULL CHOKE fut-OFF START Ey SWITCH ENGINE OIL DRAIN PLUG
1-4 PARTS AND SERVICE INFORMATION PECS FS Typhoon owners should record the name and telephone number of their Service Center. Your Service Center will be happy to supply replacement parts, accessories, and do any service or repairs to your F5 Typhoon Blower. if for any reason your Send Center is unable to service your FS Typhoon Blower or supply replacement parts, contact FE CO and include the following information on the chart below.
1-5 PECS LIMITED WARRANTY FOR NEW PRODUCTS A. WHAT 18 WARRANTED? PECS extends the following warranties to the original purchaser of each new PECS consumer product subject ta the following limitations: 4.
2-1 SAFETY WARNINGS Safety Alert Symbol This Safety Alert Symbol means. “ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED This symbol is used fo call attention to safety precautions that Should be followed by the operator to avoid accidents. When you see this symbol, carefully read the message that follows and heed its advice. Failure to comply with safety precautions could result in death or serious bodily injury.
2-1 SAFETY WARNINGS 20. DO NOT use this engine on any forest covered, brush covered, or grass covered unimproved land unless a spark arrested is installed on the muffler. The arrested must be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Federal laws apply on federal lands. 24. DO NOT operate during excessive vibration 22. DO NOT heave machine unattended while in operation 23.
3-1 CABLE INSTALLATION Insert the handle into the handle mount holes. The handle can be adjusted for height, using either the top two or bot torn bwo holes, when mounting. INSERT HANDLE HERE Fasten the handle to the handle mount using (4) H-16 x 2° HOS PE{IKK1208) and (4) 3816 nylons nuts PHK121E).
3-3 THROTTLE CABLE REMOVAL AND INSTALLATION NOTE: THROTTLE CABLE 18 ATTACHED TO THE ENGINE THROTTLE AT THE FACTORY insert the end of the cable Into the hale on the throttle th the cable still inserted in the throttle, fasten the able to the engine with the fastening plate. BRIGGS & CASTRATION ATTACH THROTTLE] CABLE TO BLOWER ASSEMBLY INSTRUCTIONS 3-3 THROTTLE CABLE REMOVAL AND INSTALLATION KOHL ER Loosen the fastening plate on the throttle.
3-3 THROTTLE CABLE REMOVAL AND INSTALLATION HONDA Remove the air filter cover. Loosen the fastening plate. Slide the throttle cable through the fastening plate and fasten the cable onto the throttle, Tighten the fastening plate, AIR FILTER COVER REMOVED INSERT CABLE] EMD HERE. BLOWER ASSEMBLY INSTRUCTIONS Loosen the throttle cable fastening plate and the throttle cable clamp. Insert the throttle cable through the fastening plate and into the throttle cable camp.
3-4 AIR DIVER YER CABLE REMOVAL AND INSTALLATION The Kohl er, Honda and Briggs and Castration models use the same procedure for attaching the air diverted cable. Loosen the fastening plate on the lower left side of the engine mount frame. Slide the cable through the fastening plate. Insert the cable end into the alr diverted and frighten.
OPERATING AND MAINTENANCE 4-1 OPERATING INSTRUCTIONS NOTE: Refer to the engine manual for engine operation and starting procedure. Your F5 Typhoon Blower is designed for cleaning outdoor surfaces where the debris can be effectively blown into a consolidated area for convenient pick-up and removal. Your FS Typhoon Blower is equipped with a throttle control for adjusting the engine speed. Under normal conditions, operate the blower at the minimum throttle to accomplish your current cleaning task.
While holding the lower handle with one hand, pull up on the pivot lock pin. Pull back on the pivot rock pin until it is located above the angle setting you need. Release the pivot lock pin and it will lock into place. The figures below show the privet lock pin in the highest angle effing. HIGHEST ANGLE Adjust the angle setting as needed fo suit the task being performed. An increased angle setting is more effective for heavier and denser debris.