Installation Manual

4 of 24

ISSUED: 08-09-10 SHEET #: 061-9059-5 07-08-15

Thread two bolts (M) through four washers (N),

ceiling clamp (L), ceiling assembly (C), and two

locknuts (O) as shown.

Repeat for second ceiling clamp.

Lift ceiling assembly (C) up to I-beam and slide

ceiling clamps (L) as close to the center of the

I-beam as possible. NOTE: Tube of ceiling

assembly should be centered below I-beam.

Alternate between tightening bolts (M) of right

clamp and left clamp until bolts evenly apply force

to each clamp.

Thread four hex nuts (P) onto four bolts (M).

Thread four bolts (M) into side of ceiling assembly

(C), but do not tighten.

Installation to I-beam

• Installer must verify that the supporting beam will safely support the combined weight of all attached equipment and

hardware.

WARNING

I-BEAM

LEFT CLAMP (L)

RIGHT CLAMP (L)

TUBE

Tighten bolts (M) on sides of ceiling plate

assembly just until they touch the ceiling clamp.

Tighten hex nuts (P) until they touch the sides of

ceiling plate assembly.