Installation Manual

6 of 24

ISSUED: 08-09-10 SHEET #: 061-9059-5 07-08-15

NOTE: Follow instructions with main enclosure assembly for removal of bay door and vertical brackets.

Thread six 1/4-20 x .75" socket cap screws (G) with washers (Q) through tilt plate (B), main enclosure assembly

(sold separately), seal washer (provided with enclosure assembly), and nylock nut (H) as shown below. Tighten all

fasteners using a 5/32" allen wrench.

Installing Tilt Plate to Main Enclosure Assembly

• Tighten screws so adapter brackets are rmly attached. Do not tighten with excessive force. Overtightening can

cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become

detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

WARNING

SEAL WASHERS

MAIN ENCLOSURE

ASSEMBLY

MAIN ENCLOSURE ASSEMBLY MAY APPEAR SLIGHTLY

DIFFERENT THAN ILLUSTRATED - SHOWN WITHOUT

BAY DOOR AND VERTICAL BRACKETS