Installation

2012-09-20 #:009-9079-1

ENG - Do not begin to install your Peerless product until you have read and understood the instructions and

warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions

or warnings, for US customers please call Peerless customer care at 1-800-865-2112, for all international

customers, please contact your local distributor.

• This product should only be installed by someone of good mechanical aptitude, and fully understands

these instructions.

• Never exceed the Maximum Load Capacity on page 1.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws ﬁ rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their

holding power.

• The cart is not afﬁ xed or secured to the ﬂ oor, and may therefore tip over and/or fall if display and/or stand

is shaken or hit. Always monitor children and do not let children play alone around stand as they could get

hurt by a falling display. Not recommended for use in areas with heavy trafﬁ c.

• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and

personal injury.

Recommended cleaning steps

• The following procedures are not guaranteed to control infection. The hospital infection control administra-

tor or epidemiologist should be consulted regarding cleaning procedures and processes.

• To avoid risk of electric shock, do not expose electrical components to water, cleaning solutions or other

potentially corrosive liquids or substances.

• Do not immerse cart or cart components in liquid or allow liquids to ﬂ ow into the cart. Wipe all cleaners off

surface immediately using a damp cloth. Thoroughly dry surface after cleaning.

• Do not use ﬂ ammable cleaners on cart surfaces due to close proximity of electrical power and equipment.

• All paints and plastic cart components will withstand cleaning by most commonly used, diluted, non-

abrasive solutions such as quaternary ammonia compounds, ammonia enzyme cleaners, bleach or alcohol

solutions.

• Pen and permanent and dry erase markers can be removed with 91% isopropyl alcohol and a soft cloth.

• Iodine stains can be removed with commonly used cleaners and a soft cloth.

• Never use steel wool or other abrasive materials that will damage the surface ﬁ nish.

• Do not use strong solvents such as trichloroethylene and acetone. These solvents will damage the

surface ﬁ nish.

• It is recommended that any cleaning solution be tested on a small, inconspicuous area to ensure surface is

not harmed.

WARNING