Installation and Assembly: Recessed Cable Management and Power Storage Accessory Box Models: IBA3AC, IBA3AC-W 2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerlessmounts.
Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact your local distributor.
Before you begin, make sure all parts shown are included with your product. Parts List A B C D E F G H I J K IBA3AC Qty.
Installation to Wood Stud Wall WARNING • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws so that in-wall box is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. • Never tighten in excess of 80 in. • lb (9 N.M.). • Make sure that mounting screws are anchored into the center of the stud.
Electrical Outlet Installation 2 Remove knockout from access plate (H). Attach surge protector (J) to outlet box (K) with access plate (H) in between using two surge protector screws. Attach cover plate to surge protector using two cover plate screws. NOTE: Service of an electrical gang box and wiring shall be performed by a qualified service personnel in accordance with the NEC.
Cable Management 3 Attach access plate (H) to in-wall box (A) with five M5 x 6mm phillips screws (I) as shown in figure 3.1. Access plate knockout may be removed for optional installation of electrical gang box. Insert up to two cable management clips (E) into the desired positions in the in-wall box as shown in figure 3.2 for routing cables. Insert cable bushing (D) into in-wall box for routing cables through in-wall box. Plastic finishing cap (F) may also be used if cable management is unnecessary.
LIMITED FIVE-YEAR WARRANTY Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless® products will be free from defects in material and workmanship, under normal use, for a period of five years from the date of purchase by the original end-user (but in no case longer than six years after the date of the product’s manufacture). At its option, Peerless will repair or replace, or refund the purchase price of, any product which fails to conform with this warranty.