MOD-FPS2KIT150-B MOD-FPS2KIT150 46" - 90" (117 - 229 cm) MAX 211 lb (96 kg) ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR 1 2014-01-27 #:203-9369-2 (2014-04-11)
WARNING ENG - Before installing make sure the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury.
AVISO POR - Antes da instalação, certifique-se de que a superfície de suporte suporta a carga combinada do equipamento e das ferragens. Os parafusos têm de ser bem apertados. Não aperte em demasia, pois podem ocorrer danos ou falha do equipamento. Nunca exceda a capacidade de carga máxima. Este produto destina-se a utilização apenas em ambientes interiores. A utilização deste produto ao ar livre pode conduzir a falha do produto ou ferimentos pessoais.
ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR Symbols Símbolos Symboles Symbole Symbolen Simboli Symboly Symboly Símbolos Semboller ENG ESP FRN DEU Do not overtighten screws. No apriete de más los tornillos. Ne pas trop serrer les vis. Ziehen Sie die Schrauben nicht zu fest an. Draai de schroeven niet te strak aan. Non stringere troppo le viti. Šrouby neutahujte příliš silně. Skrutky neuťahujte príliš silno. Não apertar demasiado os parafusos. Vidaları gereğinden fazla sıkmayın.
ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR Tools Needed for Assembly. Herramientas necesarias para el ensamblaje. Outils nécessaires au montage. Für den Zusammenbau erforderliche Werkzeuge. Voor montage benodigd gereedschap. Attrezzi necessari per l’assemblaggio. Nástroje potřebné k montáži. Nástroje potrebné na montáž. Ferramentas necessárias para a montagem. Montaj İçin Gerekli Aletler. 7/32" (5.5mm) ENG To properly tighten screws: Tighten until screw head makes contact, then tighten another 1/2 turn.
ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR Parts (Before beginning, make sure you have all parts shown below). Piezas (antes de iniciar, asegúrese de tener todas las piezas siguientes). Pièces (avant de commencer, assurez-vous d’avoir toutes les pièces illustrées ci-dessous). Teile (Achten Sie vor Beginn der Arbeiten darauf, dass alle unten abgebildeten Teile vorhanden sind). Onderdelen (hoort u zich ervan te overtuigen dat u alle onderdelen hebt, die hieronder te zien zijn).
F (1) G (1) tilt box tilt plate H (2) horizontal rail I (2) L (2) J (8) vertical rail M5 x 10mm M8 x 55mm K (8) M (2) M8 x 15mm set screw N (2) 4mm allen wrench O (1) 5mm allen wrench AA (4) BB (4) M6 x 12mm CC (4) M6 x 25mm DD (4) M8 x 12mm EE (8) M8 x 25mm FF (8) spacer M6/M8 washer 7 2014-01-27 #:203-9369-2 (2014-04-11)
1 ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR Wood joist/beam Vigueta de madera Solive de bois Holzbalken Houten dwarsbalk Travetto di legno Dřevěný nosník Drevený nosník Trave de madeira Ahşap kiriş Concrete Ceiling Techo de concreto Plafond en béton Betondecke Plafond van beton Soffitto in calcestruzzo Betonový strop Betónový strop Teto em betão Beton tavan 1b 1a-1 1a-1 ENG Use stud finder to locate and mark stud center lines.
1a-3 7/32" (5.5mm) 3" (76mm) ENG Mounting hole must center on stud. ESP El orificio debe quedar centrado en el montante. FRN Le trou doit être centré sur le 7/32" montant. (5.5mm) DEU Das Loch muss am Ständer zentriert sein. NEL Boorgat moet midden op de balk liggen. ITL Il foro trapanato deve centrarsi sul montante. ČEŠ Vyvrtaný otvor musí být v středě stěny. SLK Vyvŕtaný otvor musí byť v strede steny. POR O furo tem de ser perfurado no centro da escora. TÜR Açılan delik direğin tam merkezinde olmalıdır.
1b WARNING ENG • Never attach concrete expansion anchors to concrete covered with plaster, drywall, or other finishing material. ADVERTENCIA SPN • Nunca fije los anclajes de expansión para concreto a una pared de concreto recubierta con yeso, yesocartón u otro material de acabado. ADVERTISSEMENT FRN • Ne fixez jamais des chevilles à expansion pour béton à du béton recouvert d’une couche de plâtre, d’une cloison sèche ou de tout autre matériau de finition.
1b-1 A ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR Mark mounting holes. Marque los orificios de montaje. Marquez les trous de fixation. Markieren Sie die Montagelöcher. Markeer montagegaten. Contrassegna I fori di montaggio. Vyznačte montážní otvory. Vyznačte montážne otvory. Marque os furos de montagem. Montaj deliklerini işaretleyin. 1b-2 3/8" (10mm) 3" (76mm) ENG Drill mounting holes into supporting surface (3" (76mm) minimum depth required).
1b-3 D ENG Insert anchor flush to concrete. ESP Inserte el anclaje a ras con el concreto. FRN Insérez la cheville d’ancrage au ras du béton. DEU Setzen Sie den Dübel bündig mit dem Beton abschließend ein. NEL Breng anker aan gelijk met beton. ITL Inserire il fermo a paro col calcestruzzo. ČEŠ Přestrčte ukotvenia priamo do betónu. SLK Prestrčte ukotvenia priamo do betónu. POR Introduza a bucha encastrada no betão. TÜR Tespit demirini betona takın.
2 ENG OPTIONAL: Cut pole to desired length. Cut end must be perpendicular to pole within 1/16" (1.5mm). Must use drill template MOD-ADF (sold separately) to drill new holes in pole. Refer to accompanying instructions. ESP OPTIONAL: Cut tube to desired length. Cut end must be perpendicular to tube within 1/16" (1.5mm). Must use drill template MOD-ADF (sold separately) to drill new holes in tube. Refer to accompanying instructions. FRN OPTIONAL: Cut tube to desired length.
2-2 ENG Measure distance from center of screen to ceiling (X), subtract 2" (51mm) then mark pole and cut away excess material. ESP Mida la distancia desde el suelo hasta el techo (X), reste 2" (51mm), marque el poste y corte el exceso. FRN Mesurez la distance entre le plancher et le plafond (X), soustrayez 2 po (51 mm), puis marquez le montant et coupez l’excédent de longueur.
3 O 5mm wrench L (2) A M (2) B (2) 4 N 4mm wrench B (2) F F K (4) J (4) C (2) 15 2014-01-27 #:203-9369-2 (2014-04-11)
5 5a 5b-1 5a x3 ENG Screws must get at least three full turns and fit snug. ESP Los tornillos tienen que dar, por lo menos, tres vueltas completas y quedar ajustados. FRN Il faut effectuer au moins trois tours de vis complets et bien serrer les vis. DEU Schrauben sind mindestens drei volle Umdrehungen einzudrehen und müssen fest anliegen. NEL De schroeven moeten ten minste drie hele slagen worden aangedraaid en stevig vastzitten. ITL Girare tre volte le viti che devono risultare aderenti.
5b-1 ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR Center adapter brackets vertically on back of screen. Centre verticalmente los soportes en la pantalla. Centrez les supports à la verticale de l’écran. Richten Sie die Halterungen senkrecht mittig an der Bildschirm. Centreer de beugels verticaal op de van het scherm. centra le staffe verticalmente sul dello schermo. vycentrujte konzoly svisle na zadní obrazovky. vycentrujte konzoly zvisle na obrazovky. centre os suportes verticalmente no do ecrã.
5b-3 H (2) 5b-4 N 4mm wrench K (4) K (4) 5b-5 N 4mm wrench J (4) 18 2014-01-27 #:203-9369-2 (2014-04-11)
6 N 4mm wrench +20°/-5° ENG ESP FRN DEU NEL ITL ČEŠ SLK POR TÜR 19 2014-01-27 Tighten. Apretar. Serrer. Anziehen. Aandraaien. Stringere. Utáhněte. Utiahnite. Apertar. Sıkmak.
LIMITED FIVE-YEAR WARRANTY Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless® products will be free from defects in material and workmanship, under normal use, for a period of five years from the date of purchase by the original end-user (but in no case longer than six years after the date of the product's manufacture). At its option, Peerless will repair or replace, or refund the purchase price of, any product which fails to conform with this warranty.
BESCHRÄNKTEN FÜNFJÄHRIGEN GARANTIE Peerless Industries, Inc. („Peerless”) übernimmt gegenüber den ursprünglichen Endnutzern von Peerless®-Produkten die Gewährleistung, dass diese unter normalen Einsatzbedingungen für fünf Jahre ab Datum des Kaufs durch den ursprünglichen Endnutzer (aber in keinem Fall länger als sechs Jahre nach Herstellungsdatum des Produkts) frei von Material- und Verarbeitungsfehlern sind.
OMEZENÁ PĚTILETÁ ZÁRUKA Peerless Industries, Inc. (“Peerless”) zaručuje původním koncovým uživatelům výrobků Peerless®, že budou bez vad na materiálu a provedení, za podmínky běžného používání, po dobu pěti let od data nákupu původním koncovým uživatelem (ale v žádném případě ne déle než šest let po datu výroby výrobku). Společnost Peerless dle své volby opraví nebo vymění, anebo proplatí cenu nákupu jakéhokoliv výrobku, který nebude v pořádku ve stavu, který tato záruka pokrývá.
BEŞ YILLIK SINIRLI GARANTİ Peerless Industries, Inc. (bundan sonra “Peerless” olarak anılacaktır) Peerless® ürünlerinde normal kullanım koşulları altında orijinal son kullanıcının satın alma tarihinden itibaren beş yıl süreyle (ama her halükarda ürünün üretim tarihinden itibaren en fazla altı yıl süreyle) malzeme ve işçilik arızaları olmayacağını orijinal son kullanıcılara garanti eder.
Peerless-AV 2300 White Oak Circle Aurora, IL 60502 Email: tech@peerlessmounts.com Ph: (800) 865-2112 Fax: (800) 359-6500 www.peerless-av.com Peerless-AV Europe Unit 3 Watford Interchange, Colonial Way, Watford, Herts, WD24 4WP, United Kingdom Customer Care 44 (0) 1923 200 100 www.peerless-av.com Peerless-AV de Mexico Ave de las Industrias 413 Parque Industrial Escobedo Escobedo N.L Mexico 66050 Servicio al Cliente 01-800-849-65-77 www.peerless-av.com © 2014, Peerless Industries, Inc.
