Installation and Assembly: Universal Projector Wall Arm Models: PSTA-2955, PSTA-2955-W, PSTK-2955, PSTK-2955-W Max UL Load Capacity: 35 lb (15.8 kg) 2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerless-av.
Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact your local distributor.
Before you start check the parts list to insure all of the parts shown are included. Parts List A B C D E F G H I J K L M Description wall arm adjustment tube 4 mm allen wrench M5 x 10 mm serrated socket pin screw #14- x 2.
Installation to Wood Stud Walls for PSTA-2955, PSTA-2955-W Models WARNING • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power. • Never tighten in excess of 80 in. • lb (9 N.M.). • Make sure that mounting screws are anchored into the center of the stud.
Installation to a concrete or cinder block wall for PSTA-2955, PSTA-2955-W Models WARNING • When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications.
Installation to Wall Plate For PSTK-2955, PSTK-2955-W Models 1 Secure wall arm (A) to wall plate (K) using four carriage bolts (L) and lock nuts (M). L M K A Installation to Wood Stud Walls WARNING • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
Installation to a concrete or cinder block wall WARNING • When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete surface in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications.
Assembly of Adjustment Tube 2 Slide adjustment tube (B) into wall arm (A) and adjust to the desired projector throw distance as shown. Using two separate slots on wall arm (A), lock position using two M5 x 10 mm screws (D) as shown below. Note: Securing adjustment tube (B) into wall arm (A) requires two slots.
Routing Cables 4 Routing Cables through PRGS projector mount and wall arm assembly: Guide projector cables into openings in projector mount and wall arm assembly as shown below. Insert Tube Cap (F) into end of adjustment tube (B). Note: Cables must be removed from projector before routing through wall arm. Note: Follow projector mount (PRGS) instructions to install projector. B PROJECTOR CABLES F Visit the Peerless Web Site at www.peerless-av.
