Installation Guide

4
P/N 27783 10/12
WALL SET INSTALLATION (Continued)
3. Dry Fit All Panels
Left side
panel
Left corner
panel
Back
panel
◘ Dry fit all panels and tape in place, aligning top to pencil
line.
IMPORTANT! If bathtub is not level, trim bottoms of
panels to follow slope of bathtub.

TIP: To trim side and back panels, score with utility
knife and straight edge and snap apart. Scissors may
be needed to trim corner panels.
4. Prepare for Plumbing Fixtures
X
Y
X
Y
Drill holes
from back.
◘ Measure and mark location for plumbing fixtures on back
of side panel.
◘ Using proper size hole saw, cut out plumbing fixture holes
from back side of panel.
5. Dry Fit Side Panels
Align edge with bathtub
◘ Position side panels with tape.
IMPORTANT! Align front edge of side panels with front
edge of bathtub. A space should remain in the corners
for corner panel installation.
◘ Trace side panels on wall.
◘ Remove panels.
IMPORTANT! The corner panels may overlap the side
panel.
6. Install Side Panels
Pencil line

APPLY ADHESIVE using trowel, staying within pencil lines.
◘ Press and tape each panel to wall.
IMPORTANT! If using solvent-based adhesive, pull
panel away from wall for 30 seconds to allow solvents to
escape. Re-press panel fi rmly against wall.