Installation Guide

5
P/N 27783 10/12
WALL SET INSTALLATION (Continued)
7. Dry Fit Back Panel
◘ Position back panel with tape.
◘ Trace back panel on wall.
◘ Remove panel.
IMPORTANT! For Allura, Alvea™, Enhance, Venture
®
and Vesuvia™ models install corner panels fi rst, then
back panels.
8. Install Back Panels
Pencil
line

APPLY ADHESIVE to back wall using trowel.
◘ Press and tape panel against wall.
IMPORTANT! If using solvent based adhesive, pull
panel away from wall for 30 seconds to allow solvents to
escape. Re-press panel fi rmly against wall.
9. Install Corner Panels

APPLY ADHESIVE to corners using trowel, staying within
pencil lines.

APPLY SEALANT to back of corner panel as shown.
◘ Press and tape each panel to corner wall.
IMPORTANT! If using solvent-based adhesive, pull
panel away from wall for 30 seconds to allow solvents
to escape. Re-press panel fi rmly against wall.
IMPORTANT! The corner panels may overlap the side
and back panels.
10. Allow Adhesive to Dry
IMPORTANT! Follow manufacturer’s instructions for
adhesive dry time before removing tape.