manual

1 of 2

ISSUED: 06-09-11 SHEET #: 120-9111-1

PartsList

Description Qty. Part#

A fastenerplate 4 145‐1144

B cable 4 600‐0226

C eyebolt 4 580‐0006

Model: DS-ACC765

Installation and Assembly:

Cable Release Kit

NOTE: Read entire instruction sheet before you start installation and assembly.

Before you start make sure all parts listed are included with your product.

1. Run cable (B) through hole

in pull-out mount assembly and

fastener plate (A) as shown.

2. Run cable (B) through hole

in release mechanism and up

through second row of holes in

fastener plate (A) as shown.

3. For easy accessibility:

Tape or secure loop end of

cable onto top of display or

wall.

REPEAT STEPS WITH

OPPOSITE SIDE OF VIDEO

WALL MOUNT.

HOLE

PAGE 1
Installation and Assembly: Cable Release Kit Model: DS-ACC765 A NOTE: Read entire instruction sheet before you start installation and assembly. Parts List Description A fastener plate B cable C eyebolt Qty. 4 4 4 Part # 145‐1144 600‐0226 580‐0006 Before you start make sure all parts listed are included with your product. B C 1 1. Run cable (B) through hole in pull-out mount assembly and fastener plate (A) as shown. 2.
PAGE 2
Optional Eyebolt 2 If display is placed in recess and cable cannot be pull straight up, use eyebolt (C) in corner. Run loop end of cable (B) though eyebolt (C) as shown. C 2 PULL DIRECTION LOOP Position DS-ACC765 cables in locations as shown. Additional Cable Release Kits may be required if more than three displays are mounted horizontally. 2 of 2 ISSUED: 06-09-11 SHEET #: 120-9111-1 © 2010, Peerless Industries, Inc. All rights reserved.