manual

11 of 50

ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13

Installing Adapter Brackets

To prevent scratching the display, set a cloth on a ﬂ at, level surface that will support the weight of the display.

Place display face side down. If display has knobs on the back, remove them to allow the adapter brackets to be

attached. Place adapter brackets (B) on back of display, align to holes, and center on back of display as shown

below. Attach the adapter brackets to the back of the display using the appropriate combination of screws, multi-

washers and spacers as shown in steps 6-1 and 6-2.

NOTE: Top and bottom holes must always be used.

Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.

NOTE: "X" dimensions should be equal.

CENTER BRACKETS VERTICALLY

ON BACK OF DISPLAY

MULTI-WASHER

MEDIUM HOLE FOR M5 SCREWS

SMALL HOLE FOR M4 SCREWS

LARGE HOLE FOR M6 SCREWS

Notes:

• The number of fasteners used will vary, depending

upon the type of display.

• Multi-washers and spacers may not be used,

depending upon the type of display.

• Use the corresponding hole in the multi-washer

that matches your screw size as shown.

• Tighten screws so adapter brackets are ﬁ rmly attached. Do not tighten with excessive force. Overtightening can cause

stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become de-

tached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.

• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly

secured, damage may occur to display or product may fail.

WARNING