Installation and Assembly: Flat \ Tilt Wall Mount for VESA 400x400 Model: HT642-003 Max Load Capacity: 100 lb (45.4 kg) 3215 W. North Ave. • Melrose Park, IL 60160 • (800) 729-0307 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.
Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer service at 1-800-729-0307. • This product should only be installed by a qualified professional.
Before you start make sure all parts listed are included with your product. A PARTS LIST Description A wall plate B adapter bracket C 1/4 x 2.5 round phillips screw D M5 x 12 mm socket pin serrated washer head screw E #14 x 2.5 wood screw F 4 mm security allen wrench G H I J M8 x 16 mm phillips pan screw toggler washer Alligator® concrete anchor Qty.
Attaching Adapter Bracket to Screen 1 Attach adapter bracket (B) to back of plasma screen using four M8 x 16 mm phillips screws (G). Screen 400 mm 400 mm B WARNING • Do not overtighten. Overtightening may cause permanent damage to the screen. Torque to 26-35 in • lb (30-40 kg • cm). Installation to Wood Stud Walls Use a stud finder to locate center of studs. 2 For mounting to 16" centers Using mounting bracket (A) as a template, drill four 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm).
Installation to Solid Concrete and Cinder Block Wall WARNING • When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" of actual concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" minimum from the side of the block. Cinder block must meet ASTM C-90 specifications.
Installation to Metal Stud WARNING • Product must be mounted through drywall that has a minimum thickness of 1/2" and into metal studs, 26 gauge or heavier. • Make sure that the wall will safely support the combined load of the equipment and all attached hardware and components. • Make sure that togglers are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.
Attaching Mounting Bracket Using Hook On Option 7 Attach four M5 x 12 mm serrated washer head socket pin screws (D) to the holes on the sides of mounting bracket (A) using the 4mm security allen wrench (F) provided. 7-1 Position slots of adapter brackets (B) onto the four M5 x 12 mm serrated washer head socket pin screws (D) attached to mounting bracket (A).
Mounting Bracket Using Tilt Option 8 Remove top two M5 x 12 mm socket pin serrated washer head screws (D) attached to wall plate (A). Loosen two M5 x 12 mm socket pin serrated washer head screws (D) in slot as shown in Detail 1. Once desired tilt is established tighten two M5 x 12 mm socket pin serrated washer head screws (D) in slots. D D D B D SLOT A Detail 1 8 of 8 ISSUED: 07-07-11 SHEET #: 125-9221-1 © 2010 Peerless Industries, Inc. All rights reserved.
