manual

ManualsBrandsPeerless Manualschassis componentsMIS488

2300 White Oak Circle. • Aurora, IL 60502 • (800) 729-0307 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.com

ISSUED: 11-19-07 SHEET #: 124-9135-2 01-06-11

Installation and Assembly:

Pole PC Mount

Model: MIS488

Max Load Capacity: 25 lb (11.3 kg)

Note: Read entire instruction sheet before you start installation and assembly.

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please

call Peerless customer care at 1-800-729-0307.

• This product should only be installed by a qualified professional.

• Make sure that the wall will safely support the combined load of the equipment and all attached hardware and compo-

nents.

• Never exceed the Maximum Load Capacity of 25 lb (11.3 kg).

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.

WARNING

Summary of content (4 pages)

PAGE 1
Installation and Assembly: Pole PC Mount Model: MIS488 Max Load Capacity: 25 lb (11.3 kg) Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at 1-800-729-0307.
PAGE 2
Note: Read instruction sheet before you start installation and assembly. Parts List I N Q S T U W Y Z I T Description 3/8-16 hex nut washer PC bracket 3/8-16 x 3.25" u-bolt 1/4-20 nylock nut PC mounting bracket bumper 1/4-20 x 5/8" carraige bolt safety belt Qty.
PAGE 3
WARNING • Installer must verify that the supporting surface will safely support the combined weight of all attached equipment and hardware. 1 2 Attach PC mounting bracket (U) to existing pole using four washers (N) and four hex nuts (I). Attach six bumper strips (W) to PC bracket (Q). I N W EXISTING POLE Q U S 3 Attach PC bracket (Q) to PC mounting bracket (U) using four 1/4-20 nylock nuts (T) and four 1/4-20 x 5/8" carraige bolts (Y).
PAGE 4
NOTE: Use safety belt (Z) instruction in conjuction with this step. Fasten clear strips to the two slots in PC bracket (Q). Set HD box into computer plate (B). Fasten belt with cinch buckle to belt without cinch buckle. Place tri-bar belt clips and belt guide onto belt as shown in the safety belt instructions. Feed the ends of the belt through the PC bracket (Q) slots and through tri-bar belt clip. Cinch the end of the belt so that the PC is securely held.