Installation Guide

ManualsBrandsPeerless ManualsKitchen FaucetsP199152LF-SS

Models/Modelos/Modèles

P199152LF

Series/Series/Seria

SINGLE HANDLE KITCHEN FAUCET

LLAVE DE FREGADERO UNA MANIJA

ROBINET DE CUISINE À UNE MANETTE

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin:

11/11/2015 Rev. B

87816

3/32"

(2.45mm)

(Included / Incluido / Inclus)

Para instalación fácil de su llave

Peerless

usted necesitará:

• LEER TODAS las instrucciones completamente

antes de empezar.

• LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your

Peerless

faucet you will need:

• To READ ALL the instructions completely

before beginning.

• To READ ALL warnings, care, and maintenance

information.

Pour installer votre robinet

Peerless

facilement, vous devez:

• LIRE TOUTES les instructions avant

de débuter;

• LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien;

www.peerlessfaucet.com

Summary of content (6 pages)

PAGE 1
87816 SINGLE HANDLE KITCHEN FAUCET LLAVE DE FREGADERO UNA MANIJA ROBINET DE CUISINE À UNE MANETTE Models/Modelos/Modèles P199152LF Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin: 3/32" (2.
PAGE 2
1 For Three Hole Mount Para Las Instalaciones De Tres Agujeros For Single Hole Mount Para Las Instalaciones De Un Agujero Montage Sur Trois Trous Montage sur un trou 1 1 2 7 5 5 2 6 3 3 4 4 SHUT OFF WATER SUPPLIES. Position faucet (1) with single or three hole escutcheon (2) on sink. Option: If surface of sink is uneven, use silicone under the baseplate or gasket. Install the mounting bracket (3) and nut (4) onto mounting shank (5) using wrench.
PAGE 3
2 3 4 5 4 Hot label Etiqueta roja Étiquette rouge 1 3 2 1 2 1 2 3 3 CONNECT TO WATER SUPPLIES. Make sure all fittings and end connections are free of debris. Faucet connections (1) are 3/8" compression fittings. Secure metal nut on faucet supply hoses (2) to supply valve connection (3) and hand tighten, then tighten one additional revolution with wrench. DO NOT OVERTIGHTEN.
PAGE 4
2 4 1 3 2 1 Maintenance SHUT OFF WATER SUPPLIES When replacing a part, follow the illustrated instructions provided on the back of the Repair Part Kit. 3 3 FLUSH SYSTEM / CHECK FOR LEAKS. Remove aerator (1) and turn faucet handle (2) to the full on mixed position. Turn on hot and cold water supplies (3) and flush water lines for one minute. Important: This flushes away any debris that could cause damage to internal parts. Check all connections at arrows for leaks. Replace aerator.
PAGE 5
Specify Finish Especifíque el acabado Précisez la Finition RP82336▲ Spray, Hose Assembly & Spray Support Ensamble de la Rociador, Manguera y Soporte Douchette, Tuyau Souple et Support RP82334▲ Aerator Assembly Aireador Aèrateur RP82327 Bushings, O-Rings & Set Screw Casquillo, Anillos “O” y Tornillo de Ajuste Douilles, joints toriques et Vis de Calage RP82333 Diverter Assembly Ensamble del Desviador Dérivation RP82330▲ Cap Embase Casquillo RP71267▲ Escutcheon & Gasket (1 Hole) Chapetón y Empaque (1 aguje
PAGE 6
Backflow Protection System Your Peerless® Faucet pull-out spout incorporates a backflow protection system that has been tested to be in compliance with ASME A112.18.3 and ASME A112.18.1 / CSA B125.1. It incorporates two certified check valves in series, which operate independently and are integral, non-serviceable parts of the wand assembly.