User Manual

6 of 51
ISSUED: 09-30-09 SHEET #: 056-9024-7 11-08-16
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete
anchor.
• Make sure that the wall will safely support four times the combined load of the equipment and all
attached hardware and components.
WARNING
Place projector mount assembly (A) on ceiling as a template and mark the center of the two
mountingholes.Drilltwo5/16"(8mm)dia.holestoaminimumdepthof2-1/2"(64mm).
Attach projector mount assembly (A) using two concrete anchors (C),twoatwashers(F),
andtwo#14x2-1/2"woodscrews(D) as shown. NOTE: Mounting slots on projector mount
assembly allow for 30° (±15°) of rotation before fully securing wood screw. Tighten wood screws
(D)using3/8"(10mm)socketwrench,phillipsscrewdriveror10mmopenendwrenchuntil
projector mount assembly (A)isrmlyattached.
Skip to step 5.
3
Installation to Concrete Ceilings
D
A
CONCRETE CEILING
F
C
ARROW ON TOP OF
PROJECTOR MOUNT
ASSEMBLY INDICATES
FRONT OF MOUNT