Specifications

ISSUED:10-23-07 SHEET #: 087-9016-1

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-729-0307 or 708-865-8870.

4 of 18

2-1

Single Keyhole Mounting

Insert 8-32 x 5/8" phillips screw (F) through the single hole mounting plate (B) and thread the 8-32 round key hole nut (J) a

few turns onto the 8-32 x 5/8" phillips screw as shown in figure 2.1 and figure 2.2. Be certain beveled edges of round key

hole nut face mounting plate. Do not fully secure 8-32 round key hole nut at this time. Insert 8-32 round key hole nut into

the key hole slot of speaker and slide upward into narrow end of key hole as shown in figure 2.3. Secure mounting plate to

speaker by gently pulling back on mounting plate and tighten 8-32 x 5/8" phillips screw.

fig. 2.1

fig. 2.2

fig. 2.3

If 8-32 x 5/8" screw does

not fully secure mounting

plate to speaker,

spacer (I) can be used.

2-2

Two-hole or Four-hole Mounting

Attach double hole mounting plate (A) to speaker

using two 1/4-20 x 1/2" screws (K) as shown in

figure 2.4. Four-hole speaker mount patterns can

be accommodated by positioning the mounting

plate diagonally as shown in figure 2.5.

fig. 2.4

fig. 2.5

2-3 Self-Tapped Mounting

Position double hole mounting plate (A) on back of speaker

in mounting location and use it as a template to mark

center of holes. Drill two pilot 1/8" (3 mm) dia. holes .5" (12

mm) deep. Do not drill deeper than .5".

• Do not drill or screw into the speaker where you could

possibly damage the internal components. If unsure of

location of internal components, check specifications

with manufacturer of the speaker.

CAUTION

Secure mounting plate to speaker with two #12 x 3/4" self

tapping screws (M).

SPEAKER

BEVELED

EDGES