Installation and Assembly: iPad™ Stand Models: PTS510I, PTS510I-S, PTS510I-W 1 of 6 ISSUED: 01-29-13 SHEET #:125-9353-1 02-23-13
PARTS LIST A B C D E F G H I J Description rotation plate stand tube cover plate base weldment rubber feet 5/32'' (4mm) allen wrench M5 x 10mm socket pin screw floor screw concrete anchor screw cover Qty.
1 Attach rubber feet (E) to base plate (D) as shown. E APPROXIMATE SPACING D E 2 Place stand tube (B) on base plate (D). 3 Secure assembly using two M5 x 8 mm socket pin screws (G).
Place rotation plate (A) onto stand tube (B) and secure using two M5 x 8mm socket pin screws (G). A B 5 G Insert iPad™ into rotation plate (A) and run the USB cable through the stand tube (B) and out the cable management position.
6 Hook cover plate (C) into adapter plate (A) and secure using two M5 x 8mm socket pin screws (G). C A G A 7 Alternate between landscape and portrait view by pulling out the release pin and simultaneously turning the display.
WARNING • Do not drill into mortar joints! Be sure to mount in a solid part of the cement or tile flooring. Material must meet ASTM C-90 specifications. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill. • Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor. 8 Position mount assembly in desired location. Use base plate (D) as a template to mark holes.
