Installation Guide

Washerless

Diverter Bathcock

INSTALLATION INSTRUCTIONS

P 847•244•1234 www.barclayproducts.com

9/16/10

1. Before beginning any work be sure to shut off the water supply.

2. Apply teflon tape to ends of both the hot and cold supply nipples.

Place valve body through holes in tub. Thread the large locknuts

onto the other ends of the nipples and secure the shower set to the tub.

3. a. For models 191-S and 195-S with for use with risers, assemble riser pipe to the riser coupling

assembly on the spout by tightening the coupling nut. After hand tightening, fasten securely by

using a wrench.

b. For model 205-S for use with handshower, place rubber washer into hose connection and connect

the hose to top of valve body.

4.Turn on water supply.

Tools Needed

• Wrench •

PAGE 1
Washerless Diverter Bathcock INSTALLATION INSTRUCTIONS Tools Needed • Wrench • 1. Before beginning any work be sure to shut off the water supply. 2. Apply teflon tape to ends of both the hot and cold supply nipples. Place valve body through holes in tub. Thread the large locknuts onto the other ends of the nipples and secure the shower set to the tub. 3. a. For models 191-S and 195-S with for use with risers, assemble riser pipe to the riser coupling assembly on the spout by tightening the coupling nut.