Instructions / Assembly

Stair Rail Assembly

 With protecve blanket or cardboard sll in place, lay top

rail down with cut-outs facing up.

 Install balusters into cut-outs using rubber mallet if

needed.

 Install boom rail with cut-outs facing down, line up each

baluster and tap boom rail with rubber mallet unl fully

compressed.

 Rack rail to an angle (can be adjusted in nal steps). (2a)

 Peel back ends of protecve wrap, do not remove.

Fit Upper brackets on Top and Boom rail with u-brackets

facing up. (2b)

 Peel back ends of protecve wrap, do not remove.

Fit Lower brackets on Top and Boom rail with u-brackets

facing down. (2c)

Stair Rail Insllaon

 With railing racked, stage between top and boom stair

post, use clamps to secure rail to post with u-bracket or

baluster (2d). At this me, make sure spacing is 36” (for

residenal) from nose of stair tread to top of top rail, and

42” for commercial. Also take this me to adjust angle.

 Install u-bracket to post with #8 x 1 1/4” #2 self tapping

screws, (right angle driver may be needed for ght areas).

(2e)

 With #8 x 3/4 self taping screws install brackets, (right an-

gle driver may be needed for ght areas). (2f)

 Remove the protecve lm from the top of the top rail.

Cung Stair Rail

 Lay down a protecve blanket or cardboard and place

boom rail and top rail next to each other lining up cut

outs.

 Use rail marks from 1c and use a speed square to transfer

marks to top rail. Use a pencil to clearly mark “T” for Top

and “B” for Boom rail and a “U” for Upper and “L” for

Lower ends of rail, for reference.

 From the Upper mark of Boom rail deduct 2 1/2” -

Lower mark of Boom rail deduct 1 1/2”.

 From the Upper mark of Top rail deduct 2 1/2” - Lower

mark of Boom rail deduct 1”

 Use chop saw and cut rails according to marks.