User's Manual

Install the Reader
application, or
transfer data
Tap [Yes] to install the Reader application, or transfer files from your
computer to the Reader while charging. The Reader cannot be
operated during transfer.
After the USB storage screen is displayed on the Reader, it is detected
on your computer, and the “READER” and “SETUP” drives appear on
your computer.
When the icon* turns into the icon, charging is complete.
When charging is complete, disconnect the USB cable from the Reader
and your computer.
After a short time, the [Home] screen will appear.
* This icon is only displayed when the Reader is in data transfer mode.
Charge the Reader
Tap [No], or press the (Back) button, to return to the previous
screen.
Alternatively, press the
(Home) button. The [Home] screen appears.
When the icon turns into the icon, charging is complete.
In this mode, the Reader is not detected by your computer*. When
charging is complete, disconnect the USB cable from the Reader and
your computer.
* This situation may vary, depending on the settings of your computer.
Note
Your computer must be turned on to charge the Reader. The Reader will not be charged if
your computer enters sleep mode or standby mode. Keep your computer turned on with a
stable and continuous power supply while charging the Reader.
The
(Power) button cannot be used when the Reader is connected to your computer and
charging.
If you turn off the Reader by tapping [Settings] [Device Shutdown] while in charging
mode, the Reader will stop charging.
Tip
You can also charge the Reader using the AC Adapter (PRSA-AC10/PRSA-AC1A, sold
separately). This method of charging will take approximately 2 hours to fully charge the
battery.
If the battery is depleted, charging the Reader with the AC adapter for 3 minutes will provide
enough battery power to read up to approximately 200 pages.
To change from charge mode to data transfer mode, tap the status bar to display the
notification window
tap [USB connected] [Yes].
Charge/Battery status icon
The charge/battery status icon shows the charging status or approximate remaining charge of
the battery.