User's Manual

MoCA Installation Guidelines
OL-29163-01 Rev
A
33
8 If you have not already done so, AC power cord provided with your residential
gateway. Connect the barrel connector end of the power cord into the power
input on the back of the residential gateway. Then, plug the other end of the
power cord into an AC outlet.
The residential gateway will perform an automatic search to locate and sign on
to the broadband data network. This process may take up to 2-5 minutes. The
residential gateway will be ready for use when the Power, US/DS, and Online
LEDs on the front panel of the residential gateway stop blinking and remain on
continuously. <<Please verify this step is correct.>>
9 Wait a few seconds for the device to de discovered. When discovered an LED
labeled 2.4 GHz or 5 GHz. should turn on. At this point a MoCA node should be
active in the network. <<Please verify this step is correct.>>
10 If you have not already done so, connect an Ethernet compatible device (for
example, a set-top, , computer, or PlayStation) to the residential gateway’s
Ethernet port. The ONLINE LED should turn on and the device should be ready
to use. <<Please verify this step is correct.>>
11 Follow the steps above to connect additional residential gateways to the
network; note that up 15 residential gateways can be added to a MoCA
network.<<Please verify this step is correct.>>
12 From the user interface, you can monitor a limited number of parameters
associated with the MoCA network. You may login at any time to check for
status or for troubleshooting purposes. <<Please verify this step is correct.>>