User's Manual
Table Of Contents
- Table of Contents
- Chapter 1 Legal & Regulatory
- Copyright
- Disclaimer
- Trademarks
- H.264/AVC, VC-1 and MPEG-4 License Notice
- FCC Regulations
- CE compliance
- RF Exposure Information (SAR)
- Working environment
- Additional environments not related to EMC
- REACH - Compliance Statement
- Following information is only valid for EU-member States:
- Following information is only for India
- Canadian regulatory information (Canada only)
- Canada - Industry Canada (IC)
- Following information is only for Turkey:
- Chapter 2 Introduction
- Chapter 3 Getting Started
- Chapter 4 Basics
- Using the touch screen
- Getting to know the Home screen
- Opening and switching applications
- Monitoring your tablet’s status
- Quick Settings
- Managing Notifications
- Locking your screen
- Capturing your screen
- Customizing the Home screen
- Changing the Screen Orientation
- Managing Tasks and Applications
- Connecting to a computer
- Factory Reset
- Chapter 5 Applications
- Chapter 6 Settings
- Chapter 7 Optional Accessories
- Chapter 8 Troubleshooting
- Chapter 9 Specifications
- Chapter 10 Information for Wireless Devices
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Only peripherals complying with the FCC class B limits may be attached to
this equipment. Operation with non-compliant peripherals or peripherals not
recommended by TOSHIBA is likely to result in interference to radio and
TV reception. Shielded cables must be used between the external devices
and the device’s Universal Serial Bus (USB 2.0) ports, HDMI port and
microphone/headphone combo jack. Changes or modifications made to
this equipment, not expressly approved by TOSHIBA or parties authorized
by TOSHIBA could void the user’s authority to operate the equipment.
FCC conditions
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1.
This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Contact
Address: TOSHIBA America Information Systems, Inc.
9740 Irvine Boulevard
Irvine, California 92618-1697
Telephone: (949) 583-3000
Caution: Exposure to Radio Frequency Radiation.
The radiated output power of the Wireless LAN is below the FCC radio
frequency exposure limits. Nevertheless, the Wireless LAN shall be used in
such a manner that the potential for human contact during normal
operation is minimized.
This device was tested for operations with the device contacted directly to
the human body to the back side of the EUT. To maintain compliance with
FCC RF exposure compliance requirements, avoid direct contact to the
transmitted antenna during transmitting.Please refer to the "Grand Tour"
section in this manual for the details regarding antenna location.
User's Manual 1-4