User's Manual
Table Of Contents
- Table of Contents
- Chapter 1 Legal & Regulatory
- Copyright
- Disclaimer
- Trademarks
- H.264/AVC, VC-1 and MPEG-4 License Notice
- FCC information
- CE compliance
- Working environment
- Additional environments not related to EMC
- REACH - Compliance Statement
- Following information is only valid for EU-member States:
- Following information is only for India
- Canadian regulatory information (Canada only)
- Canada - Industry Canada (IC)
- Following information is only for Turkey:
- Chapter 2 Introduction
- Chapter 3 Getting Started
- Chapter 4 Basics
- Using the touch screen
- Getting to know the Home screen
- Opening and switching applications
- Monitoring your tablet’s status
- Quick Settings
- Managing Notifications
- Locking your screen
- Capturing your screen
- Customizing the Home screen
- Changing the Screen Orientation
- Managing Tasks and Applications
- Connecting to a computer
- Factory Reset
- Chapter 5 Applications
- Chapter 6 Settings
- Chapter 7 Optional Accessories
- Chapter 8 Troubleshooting
- Chapter 9 Specifications
- Chapter 10 Information for Wireless Devices
- Index
- Glossary
Article 14 The low power radio-frequency devices shall not
influence aircraft security and interfere legal
communications;
If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio
communications is operated in compliance with the
Telecommunications Act.
The low power radio-frequency devices must be
susceptible with the interference from legal
communications or ISM radio wave radiated
devices.
Using this equipment in Japan
In Japan, the frequency bandwidth of 2,400MHz to 2,483.5MHz for second
generation low-power data communication systems such as this equipment
overlaps that of mobile object identification systems (premises radio station
and specified low-power radio station).
1. Important notice
The frequency bandwidth of this equipment may operate within the same
range as industrial devices, scientific devices, medical devices, microwave
ovens, licensed radio stations and non-licensed specified low-power radio
stations for mobile object identification systems (RFID) used in factory
production lines (Other Radio Stations).
1. Before using this equipment, ensure that it does not interfere with any
of the equipment listed above.
2. If this equipment causes RF interference to other radio stations,
promptly change the frequency being used, change the location of
use, or turn off the source of emissions.
3. Contact an authorized TOSHIBA service provider if you have
problems with interference caused by this product to Other Radio
Stations.
2. Indication for Wireless LAN
The indication shown below appears on this equipment.
1. 2.4 : This equipment uses a frequency of 2.4GHz.
2. DS : This equipment uses DS-SS modulation.
3. OF : This equipment uses OFDM modulation.
4. 4 : The interference range of this equipment is less than 40m.
TOSHIBA AT300SE series
User's Manual 10-6