User's Manual

ManualsBrandsPEGATRON ManualsElectronicsNFC

VP-NFC

1. Introduction

PN65OEV1 combines in a single package a Near Field Communication (NFC)

controller . It is optimized for low power consumption with fully host controllable

power states.

2. Features

Host Interface: UART

UART Baud Rates: 9600、28800、115200、230400、460800

Transmission modes: ISO/IEC 14443 A、ISO/IEC 14443 B、MIFARE、Sony

FeliCa

Operating ambient Temperature: -25

。

C ~+85

。

Input Voltage: +1.8V

RF Clock: 13.56M Hz

Oscillator: 27.12M Hz

PCB:4 Layer

Weight: Approx. 3g

3. NFC antenna outline

4. Installing the device drivers

To install the device driver in your computer:

Step1. Run NXP_NFC_Drover_Pakcage

Summary of content (10 pages)

PAGE 1
VP-NFC 1. Introduction PN65OEV1 combines in a single package a Near Field Communication (NFC) controller . It is optimized for low power consumption with fully host controllable power states. 2. Features Host Interface: UART UART Baud Rates: 9600、28800、115200、230400、460800 Transmission modes: ISO/IEC 14443 A、ISO/IEC 14443 B、MIFARE、Sony FeliCa Operating ambient Temperature: -25。C ~+85。C Input Voltage: +1.8V RF Clock: 13.56M Hz Oscillator: 27.12M Hz PCB:4 Layer Weight: Approx. 3g 3. NFC antenna outline 4.
PAGE 2
Step2.
PAGE 3
Step3. Choose “Next” Step4.
PAGE 4
Step5.
PAGE 5
. NFC use cases Reader mode Peer-To-Peer 6. Antenna Detecting Range 7. Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 6
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 7
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:VUIVPNFC”. The grantee's FCC ID can be used only when all FCC compliance requirements are met.
PAGE 8
This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
PAGE 9
peut pas être utilisé sur le produit final. Dans ces circonstances, l'intégrateur OEM sera chargé de réévaluer le produit final (y compris l'émetteur) et l'obtention d'une autorisation distincte au Canada.
PAGE 10
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains IC:7582A-VPNFC”.