User's Manual

ManualsBrandsPEGATRON ManualsComputers & AccessoriesWireless MPCI Card

Table Of Contents

WL-227N_ABAND

Mini PCI WiFi (802.11 a/n) Card

Hardware and Driver Reference

Summary of content (7 pages)

PAGE 1
WL-227N_ABAND Mini PCI WiFi (802.
PAGE 2
CONTENTS CONTENTS..................................................................................2 INTRODUCTION..........................................................................3 SCOPE.............................................................................................. 3 ACRONYMS AND DEFINITIONS...................................................... 3 GENERAL FEATURES...................................................................... 3 Driver Installation................................
PAGE 3
INTRODUCTION SCOPE The purpose of this specification is to document the requirements for 802.11 a/n, it is an iNIC card that not only can act as a traditional AP/Router but also provide WLAN dual band access capabilities.
PAGE 4
Driver Installation Driver installation for Linux 1. Insert USB flash disk & WL-227N_ABAND NIC before booting 2. Boot Linux system and login 3. Create path [Wireless]: mkdir /etc/Wireless 4. Mount USB Hard Disk: mount /dev/sda1 /mnt 5. Copy tar file to Linux from USB Hard Disk: cp /mnt/2008_0812_RT2880_iNIC_v1.1.8.0.tar.bz2 /etc/Wireless/ 6. Decompress tar file to /etc/Wireless/, and it will generate a directory [2008_0812_RT2880_iNIC_v1.1.8.0]: tar -jxvf /etc/Wireless/2008_0812_RT2880_iNIC_v1.1.8.0.tar.
PAGE 5
Driver Installation 9. Setup and bootstrap WL-227N_ABAND NIC: a. Setup WL-227N_ABAND NIC: insmod /etc/Wireless/RT2880/module/rt2880_iNIC.ko mode=sta • If it shows “ra0:Ralink iNIC at 0xe0cc0000(hardware address), 00:43:0c:00:00:00 (MAC address), IRQ169 (IRQ address)”, the NIC is boot strap successfully. b. Bootstrap NIC parameters: • IP address: ifconfig ra0 inet 192.168.0.
PAGE 6
SAFETY INFORMATION Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 7
Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. USERS MANUAL OF THE END PRODUCT: In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied.