WL-194g (Wireless PCI Express Card)
CONTENTS CONTENTS..................................................................................2 INTRODUCTION..........................................................................3 SCOPE ............................................................................................. 3 ACRONYMS AND DEFINITIONS ..................................................... 3 GENERAL FEATURES ..................................................................... 3 RF PERFORMANCE ....................................
INTRODUCTION SCOPE The purpose of this specification is to document the requirements for 802.11 b/g, it is PCIe x1 standard Card for use in Desktop computers.
INTRODUCTION LED BLINK DEFINITION 2-pin header is added on PCBA and it is capable to drive one LED and provide the radio status. The LED is super yellow-green & radio status is shown below. Status LED (Yellow & Green) OFF Device is disabled or radio is OFF ON Radio is ON SPECIFICATION Antenna Length Connector Color Operating Freguancy Polariation Type Type of Radiation Peak Gain Impedance V.S.W.R. Coaxial Cable 82.5±2mm SMA Plug Reverse Black 2.4~2.5GHz Linear Vertical Omni-directional 2.
DRIVER INSTALLATION 1. Connect the wireless module and Windows will begin the driver installation wizard. . Select the first option “Locate and install...” . Select the second option “Browse my computer...” . Find the wireless module driver folder for your system. . Click Next to begin installing the drivers. 6. After installing, information will be given by Windows.
DRIVER INSTALLATION DRIVER INSTALLATION (details) Before driver installation, the wireless module will be shown under “Other devices”. Detailed device info. 6 After driver installation, the wireless module will be shown under “Network adapters”. Detailed driver info.
DRIVER INSTALLATION NETWORK CONNECTIONS Windows Control Panel gives you access to managing “Network.and. Internet” settings. In Windows Network and Sharing Center, you can “manage.network. connections.” Right click Wireless Network Connection to connect to available networks.
SAFETY STATEMENTS Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
SAFETY STATEMENTS FCC Radio Frequency (RF) Exposure Caution Statement This equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instructions in the user’s manual. This equipment is for operation within indoor frequency ranges and is restricted to indoor environments only. FCC Caution: Any changes or modifications not expressly approved by the party.responsible.for.compliance.
SAFETY STATEMENTS Wireless Operation Channel for Different Domains N. America Japan Europe ETSI 2.412-2.462 GHz 2.412-2.484 GHz 2.412-2.472 GHz Ch01 through CH11 Ch01 through Ch14 Ch01 through Ch13 France Restricted Wireless Frequency Bands Some areas of France have a restricted frequency band. The worst case maximum authorized power indoors are: • 10mW for the entire 2.4 GHz band (2400 MHz–2483.5 MHz) • 100mW for frequencies between 2446.5 MHz and 2483.5 MHz NOTE:.Channels.10.through.13.inclusive.
SAFETY STATEMENTS Notes: WL-194g Hardware & Driver Reference 11
