User's Manual
Page 16 of 52PTCarPhone 6 User Manual
Instructions for Mounting
Recommended Antennas
LTE: Hirschmann Magnetic Mount Antenna CEL 70
26 RD M/SMA/2.5 (Order No. US: HCEL-MX-0150A-02,
Order No. EU: 955 006-002), cable length 2500 mm
GPS: Taoglas Titan GPS/GALILEO Antenna AA.105
(Order No. AA.105.301111), Cable length 3000 mm
WiFi: Proant Ex-It 2400 28 SMA (Order No. PRO-
EX-347), no cable
SIM card
Mini SIM card with mobile phone contract with phone
and data plan, supporting SMS, LTE and VoLTE. This is
available from your mobile phone provider.
TIPS:
If the PTCarPhone should be operated with the
same telephone number as the mobile phone of
the user, it is recommended to use a so-called
multi SIM card. For this, contact your mobile phone
provider.
It is recommended to make sure before assembly,
whether the electronics box should be positioned
so that easy access to the SIM card is provided.
Screws and adhesive tape
Depending on the installation situation it can be
necessary to fasten the electronics box, the handset
and the accessories with other fastening material than
that which is partially supplied. Please do not forget:
Safety rst! Nevertheless, it is recommended to pay
attention to aesthetics.
Optional Connections
I/O cable installation set (accessory)
CAUTION:
The respective operating voltage of the vehicle elec-
trical system is applied to the I/O connection. Please
keep this in mind when selecting your I/O components.
The six programmable inputs and outputs of the PTCar-
Phone offer the possibility of the phone being used as
a control unit for vehicle accessories. The accessory set
contains 12 strands and a plug housing. The crimped
contacts of the strands are pushed into the plug hous-
ing as needed.
Connection specications:
12
6 5 4 3 2 1
11 10 9 8 7
PIN Signal
1, 2, 3 GND
4, 5, 6 U
B
+
7 to 12 I/O 1 to 6
I/O connection (Top view)
Types of connection:
Additional Required Hardware
LTE antennas
Two LTE antennas or LTE MIMO antenna with SMA con-
nector (not in scope of supply).
GPS antenna
GPS antenna with SMA connection (not included in the
scope of supply). Power supply: 3.3 V, max. 50 mA;
WiFi antenna
WiFi antenna with SMA connection (not included in the
scope of supply).
Key connection
I/O
GND
Relay connection
U
B
+
I/O