User's Manual
Page 44 of 52PTCarPhone 6 User Manual
Power Consumption
Off < 0.07 watt
Standby: about 1.5 W to 3 W (depending on con-
nected accessories)
Max. power consumption during hands-free mode:
2 A
Temperature
Operating: -20 °C to 70 °C
Storage: -30 °C to 80 °C
Fuses
Fuse for permanent positive: 5 A mini blade type
fuse
Fuse for ignition: 2 A mini blade type fuse
Antennas
Connectors: SMA (two for LTE antennas (MIMO), one for
the GPS antenna, one for the WiFi antenna)
Four antennas with SMA connector are required for
the operation of the phone, WiFi and satellite navi-
gation. The antennas are not included in the scope of
delivery.
NOTE: Be aware of the antennas‘ installation
conditions in the vehicle. Please contact your
qualied mobile personnel with any questions.
Approvals
USA
FCC ID 2AU9JPTC6
This device complies with part 15 of the FCC Rules. Op-
eration is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired oper-
ation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation. This equipment
generates, uses and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
Additional Information
interference will not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
Consult the dealer or an experienced radio/TV tech-
nician for help.
Canada
IC: 25691-PTC6, Hardware Version Number (HVIN: 01)
This device contains licence-exempt transmitter(s)/re-
ceiver(s) that comply with Innovation, Science and Eco-
nomic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including
interference that may cause undesired operation
of the device.
L’émetteur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada appli-
cables aux appareils radio exempts de licence. L’exploi-
tation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.