User's Manual

PARTIAL SECTION 13
Conference Call
When two calls arein progress (one active and one on hold),
press and hold the “Phone” button until you hear a double
beep indicating that the two calls have been joined into one
conference call.
Three-Way Calling
To initiate three-way calling, press the “Voice Recognition”
button while a call is in progress and make a second phone
call as described under "Making a Second Call while Cur-
rent Call in Progress." After the second call has established,
press and hold the “Phone” button until you hear a double
beep indicating that the two calls have been joined into one
conference call.
Call Termination
To end a call in progress, momentarily press the “Phone”
button. Only the active call(s)willbeterminatedandif there
is a call on hold, it will become the new active call. If the ac-
tive call is terminated by the far end, a call on hold may not
become active automatically. This is cell phone dependent.
To bring the call back from hold, pressand hold the “Phone”
button until you hear a single beep.
Redial
•
Press the “Phone” button to begin.
•
After the "Ready" prompt and the following beep, say
"Redial."
•
The UConnect™ system will call the last number that
was dialed on your cellular phone.
NOTE: This may not be the last number dialed from the
UConnect™ system.
Call Continuation
Call continuation is progression of a phone call on UCon-
nect™ system after the vehicle ignition key has been
switched to off. Call continuation functionality available
on the vehicle can be any one of three types:
•
After ignition key is switched off, a call can continue
on the UConnect™ system either until the call ends or