User's Manual

_______________________________________________________________________________________________________________ Seite 16
peiker acustic GmbH & Co. KG, Max-Planck-Straße 32, D-61381 Friedrichsdorf, Amtsgericht Bad Homburg HRA 1897
phG: peiker Verwaltungs GmbH, Vorsitzender der Geschäftsführung: Andreas Peiker, Geschäftsführer: Stephan Graf von der Schulenburg, Amtsgericht Bad Homburg 1369
Vorsitzender des Aufsichtsrates: Prof. Dr. Agilolf Lamperstorfer Ein Unternehmen der peiker Firmengruppe
4 Evaluation Kit
For the NAD V1082-x13 there is an evaluation board available.
Features :
- On board 12V DC power supply or 3,8V DC direct connected (i.e. unbuffered).
- USB port type B
- SIM card tray
- 40 pin header connected to the systemconnector of the NAD
- 3 GSPI Port connected to DB9 or pin header. Can be configured as UART od SDIO or SPDIF to
connect audio codecs
Using the evaluation board with on board 3.8V regulator
- Connect 11 .. 14V DC to power connector 1) (use delivered cable)
- Power on the board with switch 2).
Using the evaluation board with an external power supply
- Remove Jumper 3)
- Switch 2) to off condition
- Connect external supply V+ 3.6 .. 4.0V DC to connector 4) (nominal 3.8V DC)
- Connector 4): Pin1: GND
Pin2: Sense GND
Pin3: Sense V+
Pin4: V+
Note: Make sure that the external power supply is not generating spikes or
hazards higher than 4.2V. NAD Module gets damaged when spikes or hazards
above 4.2V are applied
RF Connector
- For RF measurements use main antenna connector 5)