User's Manual

Maintenance and Adjustment
170
Headlight Adjustment
Each headlight can be adjusted by
means of vertical and horizontal
adjustment screws located on the rear
of each headlight. In addition, the
headlight is equipped with an easily
accessible adjuster to allow the vertical
adjustment to be corrected when the
motorcycle is fully loaded.
1. Horizontal adjustment screw
2. Vertical adjustment screw
3. Headlight adjuster lever for loaded
conditions
Switch the headlight dipped beam on.
Turn the vertical adjustment screw on
the headlight clockwise to raise the
beam or anti-clockwise to lower the
beam.
Turn the horizontal adjustment screw
clockwise to move the beam to the right
or anticlockwise to move the beam to
the left.
Switch the headlights off when the beam
settings are satisfactory.
Headlight Adjustment Lever for Loaded
Conditions
1. Headlight adjuster lever (unloaded
position)
2. Headlight adjuster lever (loaded
position)
For normal (unloaded) conditions the
headlight adjuster lever should be set in
the horizontal position (1).
For loaded conditions rotate the
headlight adjuster downwards until it
stops (2). This will lower the headlight
beams by approximately 2°.
3
2
1
1
2