User Manual

20
LOCKING AND UNLOCKING THE VEHICLE
REPLACING THE KEY FOB
BATTERY
WARNING: Risk of explosion if
battery is replaced by an incorrect
type. Dispose of used batteries according
to the battery manufacturer’s instructions.
WARNING: The remote control
supplied with this product contains a
coin/button cell battery. If the coin / button
cell battery is swallowed, it can cause
severe internal burns in just 2 hours and
can lead to death. Keep new and used
batteries away from children. Of the
battery compartment does not close
securely, stop using the product and keep it
away from children. If you think Batteries
might have been swallowed or placed
inside any part of the body seek immediate
medical attention.
If the vehicle detects that the key
fob battery is low, a message will
be displayed in the touch panel:
"Key Fob Battery Low".
If your key fob battery is low at the time of
service, it will be replaced as part of your
normal service procedure.
To change the key fob battery:
1. Place the key fob button side up on a
soft surface
2. Carefully use tip of finger to release
cover at opening
3. Remove the cover to expose the key
blade nested in tray
4. Remove the key blade to access the
battery cover
5. Install a new battery (type CR2032)
with the ‘+’ side facing upwards. If
possible, avoid touching the flat
surfaces of the battery because finger
marks will reduce battery life. Wipe the
battery clean before installing
6. Reassemble the key fob by sliding the
battery tray into place until it latches
Used batteries must be disposed of
according to the battery
manufacturer’s instructions.
CARING FOR THE KEY FOB
CAUTION: The key fob contains
delicate electronic circuits and must
be protected from impact, water damage