User's Manual

C1303M-B (5/05) 5
Installation
To install the camera module do the following:
1. Refer to Figure 1. Loosen the set screw at the back of the enclosure with the provided 1.5 mm Allen wrench.
Figure 1. Loosen Setscrew
2. Use the supplied spanner wrench to loosen the back of the camera enclosure (refer to Figure 2). Once the back is loose, use your hands to
continue to loosen it until it can be removed.
Figure 2. Remove Back Cap of Enclosure
WARNING: To avoid thread damage, carefully remove the back of the enclosure. Never use force to remove the back of the camera
enclosure.
SET SCREW
CAMERA
ENCLOSURE
BACK
SPANNER
WRENCH