® PMC9A High-Resolution Color Monitor Installation/ Operation Manual C1909M (4/01) Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.
CONTENTS Section Page IMPORTANT SAFEGUARDS AND WARNINGS ................................................................ 3 DESCRIPTION ................................................................................................................... 4 INSTALLATION .................................................................................................................. 4 OPERATION .....................................................................................................................
IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Operate this unit only from the type of power source indicated on the label. 2. Do not block or cover ventilation openings on the back or bottom of the monitor cabinet. 3. Do not place this monitor near a radiator or heating vent. 4. Do not push objects of any kind through cabinet openings. This may result in fire or electrical shock. 5.
DESCRIPTION The PMC9A is a high-resolution, 9-inch (23 cm) color monitor. The unit has a resolution of 300 TV lines producing an excellent-quality picture. The monitor’s power input of 100-240 VAC, 50/60 Hz, is automatically detected upon power up. All image adjustment controls are conveniently located on the front panel of the monitor. INSTALLATION The monitor may be placed on any flat surface (desk or table) or rack-mounted.
Table A. Video Coaxial Cable Requirements Cable Type* RG59/U RG6/U RG11/U Maximum Distance 750 ft (229 m) 1,000 ft (305 m) 1,500 ft (457 m) *Minimum cable requirements: 75 ohms impedance All-copper center conductor All-copper braided shield with 95%braid coverage IN VIDEO A OUT CAMERA VCR IN VCR VIDEO B CAMERA OUT S-VHS IN VCR IN OUT AUDIO AUDIO 2 1 00598 Figure 2.
OPERATION 1. Turn the monitor ON. Wait 30 seconds for the picture tube to warm up and the power LED indicator to light. 2. Select the video source (V1, V2, S-VHS) using the VIDEO selection button located on the front panel of the monitor. 3. If required adjust the picture using the control knobs on the front panel. FRONT PANEL ADJUSTMENTS SHARP Adjust the control to obtain the clearest picture. TINT Turn the control clockwise to increase the greenish tones in the picture.
SPECIFICATIONS ELECTRICAL Input Voltage: 100-240 VAC, 50/60 Hz, automatic switching Power Consumption: 45 watts Horizontal Resolution: 300 TV lines Visual Picture Size: 9-inch (23 cm) diagonal Sweep Linearity: 10% Speaker Output: 1.0 watt (-3 dBV) GENERAL Input/Output Video: 2 BNC inputs, 75 ohms or Hi-Z 2 looping outputs Audio: 2 RCA input, Hi-Z 2 looping output S-Video: 1 DIN input Construction: Steel cabinet Finish: Black Dimensions: 8.66 (W) x 8.76 (H) x 12.48 (D) inches (22 x 22.
REGULATORY NOTICES This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.