I N S T A L L A T I O N SWM Series Spectra® Compact Wall Mount C293M-B (1/09)
Important Safety Instructions 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Installation shall be done in accordance with all local and national electrical and mechanical codes utilizing only approved materials. 3. Use only installation methods and materials capable of supporting four times the maximum specified load. 4. Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.
Installation The SWM can be mounted directly onto a wall, onto a single gang electrical box, or onto a pole using an adapter. Refer to the SWM-PA Series pole adapter manual (C294M) for pole mounting installation instructions. WALL MOUNTING To install the SWM Series wall mount directly onto a wall (refer to Figure 1 on page 4): 1. Determine the location where the mount is to be installed. 2. Use the adjustment plate as a template to drill holes into the mounting surface.
6. Attach the pendant model back box to the mount: a. b. c. d. Pull the electrical cables from the mount into the back box. Apply anti-seize lubricant (supplied) to the back box pipe threads. Screw the back box into the threads in the mount. Complete the installation using the instructions in the dome manual. MOUNTING CLEAT MOUNTING FASTENERS (NOT SUPPLIED) WALL MOUNT ADJUSTMENT PLATE 10-24 SET SCREW Figure 1.
ELECTRICAL BOX MOUNTING To install the SWM Series wall mount onto a single gang electrical box (refer to Figure 2 on page 5): 1. Thread the two inner mounting holes on the adjustment plate to be used with threaded mounting fasteners (not supplied). 2. Pull the electrical cables from the gang box through the cable hole in the adjustment plate. 3. Fasten the adjustment plate to the mounting surface with two fasteners of appropriate length and size (not supplied). 4.
Specifications MECHANICAL Construction Cast aluminum Finish SWM-GY SWM-BK Gray polyester powder coat Black polyester powder coat Mount Method Mount is secured by a set screw to a mounting cleat that is attached to a surface with two fasteners (not supplied). A gasket is affixed to the base to protect the interior from moisture. An adjustment plate is provided to allow the wall mount to be shimmed when the mounting surface is not plumb.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment.
www.pelco.com Pelco, Inc.
