Digital Camera User Manual

C2946M-D (6/08) 29
Specifications
GENERAL
Imaging Device 1/3-inch interline transfer CCD
Picture Elements
NTSC 768 (H) x 494 (V) (approx. 380k)
PAL 752 (H) x 582 (V) (approx. 440k)
Sensing Area 3/16 x 1/8-inch (4.7 x 3.5 mm)
Scanning System
NTSC 525 lines, 2:1 interlace
PAL 625 lines, 2:1 interlace
Synchronization AC line lock/internal
Horizontal Resolution 540 TV lines
Electronic Shutter Range
NTSC 1/60-1/100,000 second
PAL 1/50-1/100,000 second
Auto Iris Lens Type DC drive (autosensing)
Sensitivity 0.4 lux, f/1.2, 50 IRE, AGC on, 89% scene reflectance
Minimum Illumination 0.3 lux, f/1.2, 50 IRE, AGC on, 75% scene reflectance
Signal-to-Noise Ratio >48 dB
Vertical Phase Adjustable ±90°
Automatic Gain Control Selectable: on/off
Electronic Shutter Control Selectable: on/off
Backlight Compensation Selectable: on/off
Eclipser Function Selectable: on/off
Flickerless Mode Selectable: on/off; 1/100 sec (NTSC), 1/120 sec (PAL)
Auto White Balance Selectable: on/off, 2 modes
Signal Processing Digital signal processing (DSP)
Video Output 1 Vp-p, 75 ohms
Gamma Correction Selectable: on/off, 0.6, 1.0
White Balance Range 2,500° to 9,500°K
ELECTRICAL
Power Requirements
C10CH-6 24 VAC ±15%/12 VDC ±15%, 60 Hz
C10CH-6X 24 VAC ±15%/12 VDC ±15%, 50 Hz
C10CH-7X 220 to 240 VAC, 50 Hz
Power Consumption 3 W
Power Connector 2-pin terminal strip, push-in type
Video Connector BNC
Auto Iris Connector 4-pin connector (miniature square)
Controls 5-position button
MECHANICAL
Lens Mount CS mount
Camera Mount 1/4-inch UNC-20 screw, top or bottom of camera housing