Digital Camera User Manual

C2946M-D (6/08) 9
Camera Layout
Figure 1. C10CH Series Camera
ì Camera Mount: Use the top or bottom mount hole. The maximum thread depth is 0.25 inches (6.4 mm). Refer to Camera Mounting on
page 11.
î Back Focus Locking Screw: Use a 1.5-mm Allen wrench to adjust the back focus (refer to Lens Focusing on page 25). Back focus is set
at the factory for a standard CS mount back focus distance.
ï Lens Mount: Mount a standard CS mount lens to the C10CH Series camera (refer to Lens Mounting on page 10). To use a C mount lens,
install a C/CS mount adapter.
ñ Auto Iris Lens Connector: Insert the 4-pin connector from the DC drive auto iris lens into this connector (refer to Lens Mounting on
page 10).
ó Setup Button: Use this 5-position button to configure the camera through the setup menus (refer to Accessing the Setup Menus on
page 15).
r Ground Screw: Use this screw terminal as a ground.
s Power Connector (refer to Connecting Power on page 12):
• C10CH-6/6X, Terminal Block: Use the 2-pin terminal block to connect either 12 VDC or 24 VAC power.
• C10CH-7X, Power Cord: A 2-terminal type cord for 220 to 240 VAC.
t Video Output Connector: Connect a coaxial video cable to this BNC connector to output the video image (refer to Connecting Video on
page 11).
C10CH-7X BACK