® DF5HD Series Heavy-Duty Fixed-Mount Dome Installation Manual C2432M-A (12/03) Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.
CONTENTS IMPORTANT SAFEGUARDS AND WARNINGS ......................................................................................................... 3 DESCRIPTION ................................................................................................................................................................... 3 MODELS ........................................................................................................................................................................
IMPORTANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and moisture. 3. Only use replacement parts recommended by Pelco. 4.
INSTALLATION IN-CEILING MODEL PREPARE CEILING 00530 00532 00531 a. Locate the center point of the mounting location. Drill a hole in the ceiling using a 3/32-inch drill. b. Insert the compass tool into the hole. Draw a circle on the ceiling using the compass tool and a pencil. Cut the circle out of the ceiling. c. Use the mounting ring as a template and mark the hole pattern onto the mounting surface. Prepare the holes.
INSTALLATION PENDANT MODELS MOUNT AND INSTALL THE BACK BOX NOTE: If installing outdoors make sure the installation is properly sealed to keep moisture out. 00540 00541 c. Screw the back box into the mount. If outdoors, apply thread compound (provided) to the threads on the back box. a. Install the mount for the pendant dome. Refer to the instructions supplied with the mount. Bring the wiring for the dome through the mount. Refer to Tables A and B for cable requirements and wiring distances. b.
CAMERA AND LENS INSTALLATION To install the camera and lens: 1. Extend the lens to the maximum length before installing in the back box. 2. Attach the camera to the tilt table with the 1/4-20 screw and washers (supplied). 3. To ensure that the lens will not hit the lower dome: • Place the lower dome over the back box with the camera and lens installed (do not attach dome). • If the lens touches the lower dome, adjust the tilt table assembly. 4.
SPECIFICATIONS ELECTRICAL Input Voltage: Input Power: 24 VAC (outdoor models only) 62 vA (for heater) MECHANICAL Construction Back Box: Mounting Bracket: Lower Dome: Dimensions: Aluminum Steel Clear polycarbonate, 0.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex ® Series products (multiplexers, server, and keyboard).