Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
6
Figure 2: Accessory Pack Contents
Figure 3: Rack Mount Kit Contents
Tools and Parts Required for Installation
The following installation tools and parts are needed for installation, but are not supplied.
• Power source (110/220 VAC)
• Small Phillips screwdriver, if mounting the unit into a rack
1 Standard USB Mouse (1 ea.)
2 Bezel Keys (2 ea.)
3 Standard US Power Cord (1 ea.)
4
Power Cord (based on country designation, 1 ea.)
NOTE: Units shipped to China do not include power cords.
5 Chassis Handles (2 ea.); includes Phillips screws for installation.
6 Rubber Feet (4 ea.)
1 Sliding Mounting Brackets (2 ea.)
2 Rear Mount Rails (2 ea.), Front Mount Rails (2 ea.)
3 L-Shaped Plate Nuts (4 ea.)
4
M5*8L-H2.5 Round Head Nickel Screws (18 ea.), M4*6L-H2.5 Round Head Nickel Screws (18 ea.), 4.2*11*0.8
Nickel Washers (10 ea.)