Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
18
Installing an ENC5400 Capture Card
The unit must be turned off, unplugged, and the chassis cover open before you can install the RAID controller.
The ENC5400 capture card comes in 2- and 4-port models. The 2-port, primary card fits the unit’s PCIe x16 slot, and the secondary card,
used for 4-port installations, fits the PCI slot to the left of the PCIe x16 slot.
1. Unscrew and remove the metal filler bracket for the PCIe x16 slot.
2. Align the card with the PCIe x16 slot.
3. Gently press down on the card so that it is properly seated in the PCIe x16 slot.
Figure 1: Installing a 2-Port Capture Card
4. Insert and tighten the metal bracket screw to secure the card.