Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
26
Connecting to the Network
The primary network interface card (NIC) must be active when using the License Key Entry program to add or update IP camera licenses.
1. Connect one end of an Ethernet cable one of the unit’s network interfaces.
2. Connect the other end of the cable to an available Gigabit Ethernet port.
Figure 1: Network Cable Connection
Connecting the Power Supply
1. Connect the power cord to the unit’s power connector.
2. Connect the other end of the power cord to the appropriate power source.
Connecting the Power Supply
1. Connect the power cord to the unit’s power connector.
2. Connect the other end of the power cord to the appropriate power source.
SECONDARY
NETWORK