Addendum for C623M DX8000 Installation Manual DX8000 Digital Video Recorder C623M-ADDEN (3/04)
Contents Section Page INTRODUCTION ......................................................................................................................................................................................................... 4 ADDITIONAL WARNINGS AND CAUTIONS .............................................................................................................................................................. 4 PARTS LIST ..................................................................
Introduction The information contained in the following sections will serve as an addendum to the DX8000 Installation manual. Each item within reflects either an addition or alteration to the original manual text. Please refer to these pages in place of the original manual text where applicable. The following original document pages are affected.
Parts List Qty 1 2 1 1 1 Description Recorder Power cords (1 USA standard and 1 European standard) Keyboard Mouse Rack mounting kit 2 Rack ears 2 Rack handles 2 Chassis brackets 2 Adjustable support rails (front) 2 Adjustable support rails (rear) 6 Screws, 8-32 x .375-inch, Phillips, pan head with lock washers 16 Screws, 10-32 x .375-inch, Phillips, flat head 4 Screws, 10-32 x .750-inch, Phillips, pan head with nylon washers 10 Screws, #4, sheet metal, pan head, Phillips, black, .
Equipment Rack Mounting To install the unit in an equipment rack: 1. Remove the 12 screws fastening both left and right side plates to the unit. Save the side plates and screws for possible future use. Figure 4. Remove Left and Right Side Plates 2. Attach the handles to the rack ears using the four provided 10-32 x .375-inch Phillips flat head screws. Refer to Figure 5. 3. Using two of the supplied #4 sheet metal Phillips .375-inch pan head screws for each side, attach the rack ears to the unit.
4. Using the remaining six #4 sheet metal Phillips .375-inch pan head screws, attach the two chassis brackets to the left and right sides of the unit. Refer to Figure 6. 5. Assemble both sets of front and rear mounting rails using three 8-32 x .375-inch pan head screws and locking washers for each side. 6. Using six of the 10-32 x .375 Phillips flat head screws per side, attach the assembled mounting rails to a 19-inch (48.26 cm) equipment rack or console. 7. Place the unit onto the mounting rails.
SETTING THE SYSTEM LANGUAGE CONFIGURING THE LANGUAGE SETTING OF THE DX8000 NOTE: This feature is unavailable in the current software release. It will be available in future releases. NETWORK SOFTWARE CONFIGURATION Using the TCP/IP protocol, up to five DX8000 Series DVRs can be networked together for remote viewing and management. In addition, up to five simultaneous PC, web, and mobile clients can connect to each DVR.
Figure 28.
Client Software Setup REMOTE PC CLIENT SOFTWARE INSTALLATION Refer to the Client Applicatons Manual for current instructions on how to install the Remote PC Client software. REMOTE CLIENT EMERGENCY AGENT INSTALLATION Refer to the Client Applicatons Manual for current instructions on how to install the Remote Client Emergency Agent software. WEB CLIENT APPLICATION INSTALLATION Refer to the Client Applicatons Manual for current instructions on how to install the Web Client Application software.
® World Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada Tel: 800/289-9100 Fax: 800/289-9150 International Tel: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.
