Home Security System User Manual

10 C311M-N (6/06)

7. Install mount; refer to the installation manual supplied with the mount for instructions.

8. Turn on the power. If the red LED lights, turn off the power and proceed to the next step. If the red LED does not light, refer to the

Troubleshooting

section.

9. Plug the male Esprit system connector, located on the bottom of the pan and tilt, into the female Esprit system connector located on the

transformer module. Align the pan and tilt part number with the alignment label of the base and then attach the pan and tilt to the base

with three 1/4-20 nuts and washers (supplied).

10. Set the receiver address and system baud rate by conﬁguring DIP switches SW1 and SW2.

NOTE:

If you have a Coaxitron controller, you do not have to set the DIP switches. The Esprit will sense and automatically select settings

from Coaxitron control signals in either standard or extended mode.

To set the DIP switches:

a. Remove the plug from the left cover of the pan and tilt. It is not necessary to remove the pan and tilt cover.

b. Set the baud rate (SW1) and receiver address (SW2). For switch settings refer to the labels located on top of the camera module or

Tables A and B in the “Appendix” on page 63.

AUX 2

AUX 2 COM

AUX 2

AUX 2 COM

1N4005

OMRON G5V-1-DC12

32 VDC

ESPRIT

ORANGE WIRE

BLUE WIRE

AUX2 Schematic Drawing

USER

ACCESSORY

NOTE: CURRENT MUST NOT EXCEED 40 mA.

PART

NUMBER

MALE SYSTEM

CONNECTOR

ALIGNMENT

LABEL

FEMALE

SYSTEM

CONNECTOR