I N S T A L L A T I O N HS2000 Series High-Security Enclosures C494M-D (1/96)
Important Safeguards and Warnings Prior to installation and use of this product, the following WARNINGS should be observed. 1. Installation and servicing should be done only by qualified service personnel and conform to all local codes. 2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not be installed where exposed to rain and mouisture. 3. Only use replacement parts recommended by Pelco. 4.
Description The HS2000 high security camera enclosure is designed for indoor “corner mount” installation for such applications as elevators, parking garages, classrooms, offices, detention cells, etc., requiring maximum protection from vandalism in an unobtrusive package. Designed to fit flush to the ceiling in a corner, an optional hood (HS2000H) allows the HS2000 to be mounted lower on the wall and still retain the enclosure’s integrity.
Installation Before installing the HS2000 to a wall, make certain that the mounting surface is able to support the full weight of the enclosure plus the camera and lens. The tilt table and tilt table mounting brackets may be removed to provide adequate clearance for mounting the enclosure.
HS2000 Mounting Template C494M-D (1/96) 5
(This page intentionally left blank.
TAMPER SWITCH INSTALLATION The HS2000 enclosure comes standard from the factory with a tamper switch installed. Should it become necessary to install a replacement switch, refer to Figure 1 for the correct position of the bracket/switch and perform the following steps: 1. Remove the front cover. 2. Install the bracket/switch and secure with lockwashers and nuts. TAMPER SWITCH WIRING The tamper switch comes with both a Normally Open and a Normally Closed contact.
Exploded Assembly Diagram Figure 2.
Mechanical Parts List for HS2000 Enclosure Item No. Qty 1 C494M-D (1/96) Description Part Number 1 Bracket, Switch, Break-In HS10004313COMP 2 1 Window, 8" x 7" x .
Specifications Mechanical Window 1/4" (6.35 mm) thick impact and abrasion resistant clear Lexan Camera Mounting Adjustable tilt table Maximum Camera/Lens Size Accepts camera/lens combinations (including BNC connector) up to 3.0" H x 3.0" W x 6.0" L (7.62 cm x 7.62 cm x 15.24 cm) Enclosure Mounting Four (4) 0.390" (0.99 cm) diameter holes on protected rear surface Security Tamper-resistant screw N.O./N.C. switch contact on cover Tamper Switch Plunger type door switch with “pull to cheat” feature.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. • Three years on Genex ® Series products (multiplexers, server, and keyboard). If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or (559) 292-1981 to obtain a Repair Authorization number (RA), and provide the following information: 1. Model and serial number 2.
Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada Tel: 800/289-9100 Fax: 800/289-9150 International Tel: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.
